Sikasil GP White 295ml cartridge

SKU: 003-010-432064

$22.44 /each

Ontario Concrete Accessories - E-Commerce

In Stock

In-Store Pick-Up

Delivery Available

Fulfillment options will be available at the checkout.

Description

Sikasil®GP is a general purpose, one-component, non-sag, elastomeric, acetoxy and anti-microbial (mildew resistant) silicone sealant/adhesive suitable for interior and exterior applications. Sikasil®GP is also available in a high temperature (HT) grade.

Product Details
  • Shelf Life: 24 months in original, unopened containers when stored at or below 32 °C (90 °F). A product skin may form in the container, remove before use.
  • Service Temperature:
    • Standard Grade -62.2 to 232 °C (-80 to 450 °F) permanent
    • HT Grade -62.2 to 260/288 °C (-80 to 500/550 °F) permanent/intermitttent
Product Application
  • The number of joints and the joint width should be designed for a recommended joint movement of +/- 25 % at time of installation.
  • The depth of the sealant should be 1/2 the width of the joint. The minimum sealant depth is 3 mm (1/8 in), the maximum is 1 mm (1/2 in).
  • To control the sealant depth, use a closed cell polyethylene, non-gassing polyolefin or open cell polyurethane backer rod. Closed cell backer rod should be 25 % larger than joint width; do not compress more than 40 %. Open cell should be compressed 40 %. Do not use open cell rod in horizontal on grade joints.
  • If the joint depth does not allow for a backer rod, use polyethylene bond breaker tape to prevent three-sided adhesion.
  1. Application As Joint Sealant: For best performance Sikasil®GP should be gunned into joints when joint slot is at the mid-point of its designed expansion and contraction. Do not open the product container until preparation and, where necessary, priming work has been completed. When installing during time of large temperature fluctuations, such as spring or fall, and in joints designed for movement greater than ± 12.5 %, be aware that significant joint movement before cure, may cause aesthetic issues such as ripples in the sealant surface. Performance will not be affected. Apply the sealant using a professional caulking gun or dispensing equipment. Place the nozzle deep into the joint and gun with a steady and even flow of sealant preceding the nozzle to avoid air entrapment. Also avoid overlapping of the sealant as this also entraps air. Extrude in one continuous operation with consistent positive pressure to force the material into the joint. Tool the sealant at once after application and before a skin forms (approximately 10 minutes). Tool to a concave shape and ensure adequate pressure to achieve maximum adhesion with the joint walls. Dry tooling is recommended. Note: Do not use spray water or other liquids when tooling.
  2. Application As Bonding Adhesive: Apply by caulking gun, dispensing equipment or trowel. Use sufficient quantity of adhesive to one or both substrates to provide designed contact area. If needed, use fasteners or temporary support to hold substrates until adhesive has cured. Cure times vary with temperature, humidity and porosity of joined substrates.

Sold in 24 packs